HR Watermarked 25mm Solenoid Mastervalve with Flow Control

HR Products 25mm Watermarked Solenoid Valve with flow control is perfect for domestic irrigation systems. This Mastervalve is commonly used as a master valve (pump) on irrigation controllers to control the mains water supply to the system. 

25mm male female thread inlet / outlet with flow control and 24vac solenoid MV100. MV100 - Solenoid Valve Solenoid control valve with high flow and low pressure loss for use in drip, spray, and pop up sprinkler watering systems. Valve has been designed to utilise a minimum number of internal parts to ensure reliability and cost effectiveness. 

FEATURES:

• Body material natural Nylon 66 30% glass filled
• Solenoid outer casing natural Nylon 66 30% glass filled
• Stainless steel plunger with natural Nitrile elastomer tip
• Natural Nitrile elastomer diaphragm
• Flow control
• Internal manual bleed
• Female inlet / outlet bsp threads to AS1722
• WATERMARK approval ATS 5200.030-2004.
• (Plumbing & drainage products – Solenoid valves)

ELECTRICS

• Solenoid encapsulant Nylon 66 (30%) Glass filled 
• Magnetic stainless steel grade plunger 
• Natural Nitrile elastomer plunger tip 
• Stainless steel 302 plunger spring 
• Voltage 24V AC 50Hz 
• Voltage tolerance +10% or -10% 
• Power consumption 4.5 VA 
• Inrush current 400mA, Holding current 200mA 
• Electrical connections to field wires are made via the two flying leads protruding from valve using King One Step Dry Conn model 61135, 61235 or similar

OPERATION

The valve will operate correctly within the following conditions

• Ambient temperature 2° C to 60° C
• Relative Humidity 0% to 100%
• Temperature of water 2° C to 40° C
• Direction of flow markings on body (check before installing)
• Flow range 5lpm to 100 lpm
• Minimum operating pressure 70 kpa
• Maximum operating pressure 1250 kpa
• Supply pipe velocity range 1.2 m/s to 6.5 m/s

For best performance valve should be installed in horizontal position with solenoid in an upright position.