Mt Profil Tank Level Indicator Gauge

The HR Products MT-PROFIL Mechanical float-operated water level gauge is specifically designed for easy installation on potable and rainwater tanks. This versatile gauge features a reversible face plate, allowing for two different height ranges. On one side, it accommodates tanks up to 1.5m in height, while the other side caters to water tanks up to 2.5m in height. With this gauge, you can always rely on accurate and precise readings of the current water level in your tank.

SPECIFICATIONS

• 40mm bsp male thread
• Interchangeable scale 0-150cm & 0-250cm

FEATURES

• Suitable up to 2.5 metres deep
• Easy mounting on top of tank using optional back nut
• No batteries or wiring are required
• Easy to read 90mm dial face
• Dial face registers zero when tank is empty
• Dial face registers 150cm or 250cm (depending on set scale and tank height) when tank is full
• Reversible dial face to suit 250cm deep tanks Weighted float to ensure correct depth reading

HOW TO INSTALL

Depending on the height of the water tank, select the dial that will give you the best accuracy. Drill a 40mm hole into the tank and drop the float through it. Screw down the optional back nut using two self tapping stainless steel screws. Adjust the dial by rotating it clock or anti-clockwise so that the maximum water depth is aligned with the red line on the dial face plate.

CHANGING SCALE

Tank gauge is supplied set to 150cm scale. To set gauge at 250cm flip face plate off being careful not to damage the O-ring seal, slide scale right and lift over needle. Turn the gauge over and slide back into place, making sure the face is lined up with the correct float indication height.

SETTING FULL POINT

The tank FULL watermark is indicated when the black needle is aligned with the red indication line. This indication means the float is positioned directly under the gauge and the tank is at full capacity. When first installed this set point will change due to the thickness of the tank material, gently rotate the black needle to align with the red indicator mark to reset this point. Failing to reset this indication mark will result in overfilling the tank. Note: There is a spring loaded mechanism in the gauge that retracts the cord. If the float is disconnected, and the cord is allowed to slip into the gauge then the spring will unload and the gauge will stop working. This will void the warranty.