Holman Chatterbox Budget Valve Locator

In stock & available in-store

Need to locate a buried solenoid valve? Then you’ve come to the right place! This easy-to-use unit fits in the palm of your hand and can be quickly connected to any 24-volt irrigation controller to help you find hidden valves. Holman Valve Finder Tool.

Once connected to the specific zone wire at the irrigation controller, the unit will cause the solenoid on the buried valve to “chatter”, and the vibrations and sound will lead you right to its location. 

Simple enough to successfully locate valves in minutes, yet inexpensive enough for anyone to use. Don’t rent expensive wire tracking equipment – get chattering instead!

At last a simple device for locating electrically operated solenoid valves in the ground!
Just clamp onto the controller terminal block, run that station (valve) on manual operation & the coil will make a distinguishable “chattering” noise. This noise is used to locate the valve. With it’s compact size, the valve locator diagnostic device can easily be kept in your pocket, ready for use.

If the water supply is from a pump, ensure the Master Wire marked “M” or “Pump” on the controller terminal block is disconnected to avoid damage to the pump start relay or contactor.

FEATURES

• Pocket size
• No batteries required
• Used to locate solenoid valves

HOW TO USE

1. TO LOCATE A SINGLE VALVE:
Disconnect the required station number wire on the Controller Terminal Block. Clamp one alligator clip from the “Valve Locator” to the station number on the Controller Terminal block. The other alligator clip from the “Valve Locator” must be connected to the field wire. Using the manual cycle on the Controller, turn on the required station (valve). The coil on the valve will start to “Chatter” in the ground and the sound will lead you to the valve.

2. TO LOCATE ALL THE VALVES:
Disconnect the Common Wire (or wires) marked “C” on the Controller Terminal block. Clamp one alligator clip from the “Valve Locator” to the terminal marked ‘C’ on the controller. The other alligator clip from the “Valve Locator” must be connected to the Common Wire (or wires). Using the manual test cycle on the Controller, manually turn on the stations for a minimum run time of 2 minutes. The Stations (valves) will come on sequentially one at a time and you will be able to locate the valves by the
“chattering” noise.